Popcorn Machine Instructions

Setting Up:

• One appliance per power outlet.
• Place machine under a Marquee.
• Place machine on a sturdy table.
• Connect the lead of the machine to the power point.
• Flick the 'warmer' switch on to warm up the cabinet.

Popping Popcorn

Flick the 'kettle heat' switch on and the 'mixer' switch on. Let the kettle warm up for about 30 seconds and then add the popping oil.  Let the oil melt for about 10 seconds and then add the corn kernels, now sprinkle the butter salt over the kernels and flick the lid closed and wait for it to start popping.  It will take about 3 minutes.  Listen to the kernels pop and immediately the pops stop then dump your popcorn.  To keep popping repeat.  If you have finished popping switch off the mixer and the kettle heat switches.   Note:  don't leave the kettle on or it will burn and smoke.

Cleaning

Make sure all switches are in the off position.  Disconnect the power cord, then scoop out remaining popcorn.  Remove the waste tray at the bottom of the machine and discard popcorn waste before replacing the waste tray.  Wipe out the inside of the cabinet and the inside of the kettle with towelling paper to remove any oil and popcorn waste.  wipe the accessories and the waste tray and place back inside the unit. We will clean the machine on return.

WARNING:  do not disassemble the unit or wash the kettle. (Popcorn kettles cost  $450.00 to replace).

if in difficulty at any stage please phone our office. Never attempt to repair the machine yourself.